IoT setup - Acton

How to set up Acton IoT devices, connecting them to ATOM dashboard

L
Written by Liene Brokane
Updated over a week ago

Follow the below steps to configure your Acton IoT:

1) Provide your Acton device documentation, so we can check it and make sure our integration matches your Acton device;

2) ATOM prepares a server for your Acton devices, where they will send and receive signals;

3) ATOM provides you with the IP and PORT numbers for your Acton IoT server;

4) Provide this information to Acton, so they can proceed with the setup on their side;

5) Afterwards add your IoT devices/locks and your vehicles to the dashboard:

If everything is configured and added correctly, you will see that the IoT device/lock is sending its signal through. Check column "Last update: x min.", e.g. (it should show exact time when last signal was received):

Did this answer your question?